Quick print center inc1/10/2023 ![]() Open the Disk Image for the ideaMaker installed on the USB storage included with your printer or that you downloaded from After the installation is finished, click "Next" to go to the next step.Ĭlick "Finish" and ideaMaker is installed. Set a path for installing ideaMaker then click "Next".įollow the instructions and click "Install". Open the installer and choose the language. Or go to and download the ideaMaker software. The ideaMaker software is available on the USB storage included with your printer. If you want to print with the right nozzle or dual extrufers, please follow the instructions on aligning both extruders found here: Question The printer has been pre-calibrated based on printing with the left nozzle in the factory. NOTE: For your first set of prints please use the left nozzle only. Push the filament down to the feed gear until the gear grips the filament. Therefore we advise that you use this PLA for testing.įeed the filament through the guide tube. NOTE: This document is set based on the Raise3D PLA filament, which is delivered together with the printer. Finish the feeding operation step by step according to the instructions on the screen. Press the “Utilities” menu on the screen and set the temperature of the left nozzle for the filament, then press the “Load” button. When the touch screen displays "Home", the printer is ready. The printer will go through a start-up sequence. Remove the power cable from the starter box and plug the machine into a wall outlet. ![]() Slide the starter box out of the base of the printer. NOTE: The filament should load clockwise. Install the filament holder in the mounting hole on the side of the printer and place a spool of filament on the holder. ![]() NOTE: The best distance between the glass clip and the edge of print platform is 5cm. Remove the remaining build plate clips from the accessory box and secure them to the glass and heated bed plate. ![]() Make sure it snaps into the build plate clamps in this way. NOTE: Place the surface which posted with BuildTak upwards, while the yellow label is at the back left corner. Make sure it snaps into the build plate clamps at the back. Remove the glass build plate from the 8 protective foam. * Due to the difference between single and dual extrusion machines, the quantity of some of the products received will be different.īesides, there is only one fan cover in the printer with single extruder and it is has already been equipped to the printer. You can gently turn the ball screw by hand to raise the z platform to help taking out the accessory bag. Gently lift the build plate gently with your hands and remove the accessory bag under the build plate and open it for standby. The 3mm hex wrench is packed under the printing platform. Use the 3mm hex wrench to remove the Z axis clamps on both Z axis ball screws. Please save these clips and re-install them if you transport your printer. If you fail to remove these clips your printer will be damaged. Please remove the 24 clips holding the extruder assembly in place before powering on your printer. Recommend to unclip the Zipties as you are able to reuse the ties later. This is class A product, In a domestic environment this product may cause radio interference in which case the user may required to take adequate measures. * Please review this entire guide before operating the printer.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |